Somfy Z-Wave to Digital Motor Interface (ZDMI)

• Need (1) per Somfy Motor
• Used with Somfy Sonesse ST50 ILT2 (Somfy #1030053 & #1030077) and Sonesse ST30 RS-485 Motors (Somfy part #1000658). NOT suitable for new Sonesse 50 AC motors and SDN 2.0.
  
• Communicates with all Certified Z-Wave controllers
• Easy Plug-In design provides simple installation
• Includes ST30 Power Cable and RS-485 Communication Cable
  
• Must be located within 30 Ft of motor
• All motor travel limits must be set before connecting to the network. You cannot set or modify motor travel limits with this device and must use the appropriate Limit Setting Tool.
  
• Somfy part #1870171

Somfy Z-Wave to ILT Specifications Sheet
Somfy ZWave ZDMI Programming Instructions. 4Mb

This product usually shows up as a dimmer switch with a Slider Bar in a ZWave system like SmartThings, Wink, Iris etc. Since this module provides feedback to the controlling system, it is possible to specify movements in percentages of Open or Closed. When using with a sheer shade type such as a Silhouette^®, opening the vanes vary between 94%-96% and full closed at 99%. To send a shade half way closed for example, you would specify 50%. If shade alignment is critical then make sure that all open and closed limits are programmed exactly the same from shade to shade with the shade limit setting tool.

Availability: Stocked Item
Ships: 12-24 Hours