Hunter Douglas Luminette PowerView^®  Generation 2 Replacement Motor

• 18V DC OEM Gen2 replacement motor from Hunter Douglas with integrated RF receiver fits all Luminette Headrails made on or after May 5, 2010 thru May 0f 2021. Check the date on the production sticker located inside the TOP of the Luminette headrail.
• This motor requires (1) 18V DC Power Supply and (1) Power Cable selected below or use your current 18V DC Power Supply and power cables already installed.
• Note: This motor is NOT compatible with the older Platinum Technology 2.0 or 2.1 Remote Controller or Platinum Gateway OR Generation 3 PowerView Components or Remotes. This motor will fit your old Lumintte Headrail if made after May 5th, 2010. If replacing an old PowerGlide Platinum Technology motor with this new PowerView Motor - You will need to purchase a new PowerView Pebble Remote (Chosen in Option Boxes-below). Your old Platinum Technology remote will not operate this new PowerView Motor! The new PowerView Motors are side specific. While looking at your Luminette Drapery Track - If your old Platinum Technolgy PowerGlide motor was on the Left then order a new LEFT motor and if on the Right then order a new RIGHT Motor. Helpful Note: to find out when your Luminette Track was made, look inside the TOP of the headrail for a production sticker and FINISH DATE. Since most tracks are mounted at or near the ceiling, use a mirror or your cell phone camera to possibly see inside the top of the track without removing it.
  
• PCN7503001000=Motor on RIght PCN7503000000=Motor on Left

Luminette PowerView Motor Instructions 1.4Mb
Luminette PowerView Parts List
Luminette PowerView REV-H Motor Reset
Luminette Additional Components List

Availability: Special Order
Ships: 7-10 Days directly from Manufacturer (Ground Shipping only)